| The BL-Ctrl V2.0 is the newly released speed controller for any Mikrokopter. Each of these controllers are factory tested and programmed. |
The board is already 98% finished, manufactured with SMD technology. Some soldering is required to finish the board.
The BL-Ctrl kit is pre-tested and approved to be used with the Navi-Ctrl, Flight-Ctrl, MK3MAG, BL-Ctrl. This new version has the following features: •Integrated current measurementfor measuring the actual current and the used capacity
•Temperature messurement
•Voltage messurement
•Software configuration (e.g. current limit, temperature limit)
•PCB: 4-layers (increased current-measuring shunt)
•Supports batteries from 3s to 5s
•Automatic current and temperature limitation
•By high-performance MOSFETs 35A and 40A peak period are possible.
•Two LEDs (OK and Error)
•Addressing the controller by jumper (address 1 - 8)
•Various interfaces (I2C, PPM, serial)
•Drill: 3mm
•Dimension (W x H): approx 44mm x 21mm |
The following items are included in this kit:
1 x BL-Ctrl V2 SMD board. 2 x Low ESR 25V capacitor. |
Note
This is a kit, not a final product. About 10-20 minutes of work is still required to fnish this board. Most of the components are surface mounted and already assembled.
This is sold as it is for private, non-commercial use.
Please read the Terms and conditions of the software regarding commercial use.
For warranty info click here
This product was added to our catalog on Monday 23 August, 2010.
