DiY 5.8GHz Video Transmitter Kit, 100mW

$49.99USD

This DiY 5.8GHz 100mW audio/video (A/V) transmitter kit provides a custom printed circuit board and quality electronic components. Assembly is required; suitable for amateur radio hobbyists and RF technicians.

Airwave's AWM681TX RF module is included. The kit utilizes SMD components, so electronic soldering experience is essential. Once assembled, all you need to supply is a 5.8GHz antenna, camera audio/video, and battery power. Our 5.8Ghz receiver kit (available separately) is a perfect mate to this exciting A/V system.

Using FM modulation, it sends high bandwidth composite video and stereo audio signals to compatible A/V receivers. Fully supports NTSC and PAL video formats. Best of all, the assembled transmitter is very compact and lightweight.

Operating this transmitter will require a ham radio license for hobby applications. Some countries may prohibit use. Please consult your government's spectrum regulations before using this device.

Specifictions:

Quality SMD components.
5.8GHz operation avoids 2.4GHz band congestion.
Seven RF Channels (5740,5760,5780,5800,5820,5840,5860 MHz).
100mW RF power (50Ω RF port).
SMA-RP antenna connector.
High quality video (75Ω input impedance).
NTSC/PAL video compatible.
Two line level (1-volt) audio channels.

FM modulation for best A/V performance.
Operates on 6.5VDC-8.5VDC (2-cell LiPO battery compatible).
Auxiliary 5VDC @150mA output for powering camera.
Low current consumption (250mA typical).
Small size, 2.3 x 1.2 x 0.5 inches.
Light Weight, 0.8 ounces (23 grams).
Three hour assembly time (typical)
FCC / ARS Part 97 (ham radio) legal operation.

Special Note: The kit's packaging label will be identified as a Rev-B or Rev-C. Be sure to download the instructions that match the Rev number. Operational performance for both Rev numbers is the same.

Manual Rev.B Kit: Click Here

Manual Rev.C Kit: Click Here

Addendum: AV681tx_addendum1.pdf