Flight Controller ME 2.1

Note: This item is pre-order only!


This is the latest Flight Controller ME 2.1 kit for the MikroKopter.  The board is already SMD assembled, there are only a few more soldering steps to complete the board.  The gyroscopes and all major components are pre-assembled.

---

The Flight Controller kit is tested and pre-programmed (including bootloader). A SerCon or MK-USB is required for debugging and modifying the flight parameters. The following items are included in this kit:   1 x Flight Controller Board ME (2.1) 2 x Recom type swithcing regulators pre-installed  3 x Gyroscopes (installed already) 1 x Pressure sensor 3 x 6 pin headers 1 x 10 pin header 1 x Capacitor

New in version 2.1 (ME):
High quality MEMS gyros from Analog Devices 5 servo outputs 2 Swithcing voltage regulatora have been preinstalled Molex connector for easier connection to the distribution boards Extra voltage regulator for Spektrum Sattelite receiver easier to use Jeti telemetry Servo and LED pin headers Dual side surface mount, 4 layer PCB board external connection SMD pads were enlarged

Note
This is a kit, not a final product. About 1-2 hours of work is still required to fnish this board. Most of the components are surface mounted and already assembled.
This board is shipped with the latest stable firmware.
This is sold as it is for private, non-commercial use.
Please read the Terms and conditions of the software regarding commercial use.
Link to english documentation
For warranty info click here