- It allows you to use it on a singel or dual chnnel operation mode;- There is a safety feature built in, which will allow the switching to occur only after it received 5 valid switching signal pulses. This happens in about 100ms, so one cannot notice this timeframe, but it is enough for the device to prevent accidental switching caused by an RC glitch.
- This switch can be used with either 12V or 5V cameras - but all cameras have to be the same voltage.- Additional safety feature: In case the RC signal is lost, the device will switch back to Input 1 after about 2.5 seconds. The rationale behind this is the following: In case you have a forward and a backward facing camera, and you loose RC control while looking backwards, the device will switch back to the forward facing camera (assuming that this is connected to Input A) in order to allow you to look forward and resume flying the plane with forward view once you regain control. This feature is always useful to notify you that you are dangerously close to loose RC control of your plane.
Manual: Setup and Utilization Manual
This product was added to our catalog on Sunday 24 May, 2009.