Radian FPV Pan/Tilt Pod Kit

The Radian FPV pod that uses a custom mechanism allowing for full 180 degree (+/- 90 degree) panning without the need for any modifications to a servo or without the need for a servo stretcher.  A full 360 degree pan (+/- 180 degrees) is possible with the addition of an NG Hobbies SSV3.5 servo stretcher (option below).

---

A support at the rear of the pod is available for your battery(two locations to choose from!).  Although designed for a 620mAh 3s battery, many other batteries will fit in this compartment.The pod is attached to the Skywalker by a combination of the tabs at the rear of the pod and a thumb screw (included) at the front of the pod that attaches to the blind nut that comes with the SkyWalker. There are two locations for the pan/tilt assembly.  You can choose a normal or forward location during assembly (see pictures).

Comes with a mounting plate that will fit many popular FPV cameras including: KX131, KX171, KX191, IF Cam, SN777, SN555 and many others

Additional back plates may be purchased to fit IF OSD Cam, DPC OSD Cam, DX201

Note: careful routing of camera wiring is required to prevent binding during 180 degree or 360 degree operation.

---

This kit will include*:

• Laser cut components for the main pod
• Laser cut components and hardware for the 180 degree pan module (or other options available)
• Two 9g Servos (if choosing a pan/tilt option with basic servos)
• Thumb screw and retaining clip
• Velcro strap to hold battery to pod

---

You'll need to supply:

• Double sided servo tape to apply TX, camera, and tilt servo.
• Pull-ties to hold TX against tape and for holding your wiring down.
• Medium CA

---

Documentation:

Instructions to build the pan and tilt: Coming Soon